The Duckmeister wrote:The top of the remnant of the post is about 100mm below clamp level.... No "grip & twist" is possible!
Percrime wrote:Ok.. I have an idea here that might work. OK sufficiently long bit of threaded rod. nuts that will fit down the centre of the seat post... Lock a couple of those nuts together on the end Thick bit of rubber above that will just fit though that hole and another nut on top THis one needs to be really free turning.
Insert Pull up against the aluminium seat post. Turn the threaded rod. While jamming it.
It 'should' become a slide hammer.
It might work even without the expanding bolt idea
Users browsing this forum: No registered users and 2 guests