I have just replaced my old wheels (viewtopic.php?f=12&t=25519
) with new Fulcrum Racing 5s.
First ride was sweet but I noticed I had not moved the computer magnet from the old wheels to the new as I wasn't getting any reading on the computer.
I took the magnet/sensor off the old rear wheel - it was attached to the hub (or the outside flat bit to which the spokes are connected.
But on the new wheels the same bit is nowhere big enough (nor has enough clearance from the stationary sensor) to put it in the same place. I could probably only put it on one of the spokes. But it's a 4mm thick round magnet the size of a button.
ANy ideas how to attached it to a spoke? Or is there an alternative smaller magnet that I can get that will work the the current computer and sensor but attach to the spokes?